NEC Express5800/R110f-1E Manuel d'utilisateur télécharger pdf (Page 131)

131

Notes on Use of Universal RAID Utility

This chapter describes the notes on use of the Universal RAID Utility.

Operation Environment

Use of IPv6

The Universal RAID Utility cannot operate in the IPv6 (Internet Protocol version 6) environment. Use the

Universal RAID Utility in the IPv4 environment. To manage a RAID System in the IPv6 environment, use the BIOS

utility of the RAID Controller.

Support for Solid State Drive (SSD)

The RAID Viewer and raidcmd of Universal RAID Utility Ver2.31 or later, display the Solid State Drive connected

to the onboard RAID Controller (LSI Embedded MegaRAID™) as Hard Disk Drive.

After updating Universal RAID Utility from Ver2.3 or the older versions (where the Solid State Drive is displayed

as it is) to Ver2.31 in the onboard RAID Controller (LSI Embedded MegaRAID™) environment, the Solid State

Drive will be displayed as Hard Disk Drive.

To display the Solid State Drive correctly in the environment where the onboard RAID Controllers (LSI Embedded

MegaRAID™) is used, you need the driver (ver14.00.1026 or later) which supports the Solid State Drive. Please

check if the version of driver is 14.00.1026 or later.

Please be careful not to configure Logical Drive mixing Solid State Drives and Hard Disk Drives in the onboard

RAID Controller (LSI Embedded MegaRAID™) environment.

The Logical Drive of which Solid State Drives and Hard Disk Drives are the members may be created in the

following cases.

The functions of possibility mixing SSD and HDD

 Create Logical Drives (Simple/Custom)

When you select Physical Devices, please be careful not to configure Logical Drive mixing Solid State

Drives and Hard Disk Drives.

 Rebuild

Please check if the device type of the Physical Device is SSD or HDD, then replace the Physical Device with

the proper type of device before rebuilding if required.

How to distinguish SSD and HDD

Please see Property of the Physical Device and check "Capacity". The Physical Device is SSD if "Capacity" of

property displays 30GB, 50GB or 100GB.

If you want to know how to see Property of Physical Device, see "Referring to Property of Physical Device".

1 2 ... 126 127 128 129 130 131 132 133 134 135

Pas de commentaire

NEC Express5800/R110f-1E Manuel d'utilisateur Page 131