NEC Display Wall Calibrator Guide de l'utilisateur télécharger pdf (Page 78)

78 | NEC DISPLAY WALL CALIBRATOR - USER’S GUIDE

Chapter

Assigning an IP address

Displays connected via LAN need to be assigned an IP address so that they can be remotely accessed. Each display

with a LAN interface has a default IP address of 192.168.0.10. This address must be changed in order to avoid conicts

when other displays are connected to the LAN. When the LAN RESET operation is performed on a display’s OSD, the

IP address will be reset to the default value.

Most models of display support setting the network settings directly via the OSD. The following steps can be skipped

if the network settings can be congured using the OSD menu.

Important: It is recommended to reset the power to the display after changing the LAN settings in order for the new

settings to be recognized.

Setting the IP address via a web browser:

The IP address of a display can be assigned by connecting a PC directly to the LAN port on the display, or via a LAN

HUB while no other devices are connected. Note that a crossover LAN cable may be necessary on some display models

if the PC is connected directly to the display.

If the PC being used to set the IP address of the display is not currently set to access the subnet that includes the

display’s defaults IP address, it will be necessary to temporarily modify the network settings in order to assign the PC

a temporary IP address and subnet so that the display can be accessed. Once the display has been congured the PC

network settings should be restored.

Follow these steps:

Open the Network Settings properties of the PC, and select Internet

Protocol TCP/IP in the list, then click the Properties button.

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 91 92

Pas de commentaire

NEC Display Wall Calibrator Guide de l'utilisateur Page 78