NEC Express5800/R120b-2 Guide de l'utilisateur télécharger pdf (Page 538)

100

101

G-24 Installing Windows Server 2003

The procedure to set PAE option

If your 32-bit system has a memory capacity in excess of 4GB, setting PAE option will enable the

system to be installed with over 4GB of memory.

IMPORTANT:

However, the Microsoft operating system products which support /PAE

switch option are limited.

Refer to the following article in Microsoft Knowledge Base to check

the supported products.

Microsoft Knowledge Base - Article ID: 291988

"A description of the 4GB RAM tuning feature and the Physical

Address Extension switch"

In Windows Server 2003 system, the PAE option can be set by editing boot.ini.

Below is the example on how to add /PAE switch to Boot.ini file.

1. Click [Start], point to [Settings], and then click [Control Panel].

2. In [Control Panel], double-click [System].

[System Properties] dialog box will be shown.

3. Click the [Advanced] tab, and then click [Settings] under [Setup and Recovery].

4. Under [System Setup], click [Edit] to open [Boot.ini].

5. Add "/PAE" to [Operating Systems] section in [Boot.ini] file, and then save it.

[boot loader]

timeout=30

default=multi(0)disk(0)rdisk(0)partition(2)\WINDOWS

[operating systems]

multi(0)disk(0)rdisk(0)partition(2)\WINDOWS="Windows Server 2003 "

/fastdetect

multi(0)disk(0)rdisk(0)partition(2)\WINDOWS="Windows Server 2003 ,

PAE" /fastdetect /PAE

C:\CMDCONS\BOOTSECT.DAT="Microsoft Windows Recovery Console " /cmdcons

This is the end of editing Boot.ini file.

NOTE: If you choose one of the items in the "Default operating

system" drop-down list box in [Setup and Recovery] group box, you

can make your system start automatically from the switch you

specified.

1 2 ... 533 534 535 536 537 538 539 540 541 542 543 ... 555 556

Commentaires sur ces manuels

Pas de commentaire

NEC Express5800/R120b-2 Guide de l'utilisateur Page 538

Commentaires sur ces manuels

Produits connexes et manuels pour Serveurs NEC Express5800/R120b-2