NEC GammaCompMD QA Manuel d'utilisateur télécharger pdf (Page 25)

GammaCompMD QA Client User Manual

・If the operation with the PIP MODE (PbP) goes wrong, connect the PC with the display using

an USB cable. This is an alternative way of communication between PC and Display.

Refer to the display's documentation for details.

・If the restoration of PIP MODE (PbP) from OFF to ON takes unusually long time, connect the

PC with the display using an USB cable. Refer to the display's documentation for details.

・After the calibration, the BLACK LEVEL value may return to the value before the calibration

when PIP MODE (PbP) is set to OFF or ON. In this case, please set the value of BLACK LEVEL

to 50.0% by the OSD menu.

・In MD302C6, when two inputs of INPUT1+INPUT2 will be displayed, both inputs should use

the same type of connector, and set up to the same resolution. Set up coordinates according

to correct example.

・If the calibration with the PIP MODE(PbP) goes wrong, execute 7.7.1.1 Re-initialization

Display Configuration after setting PIP MODE to OFF. Execute calibration again after

re-initialization.

・When displaying two or more inputs on one screen, please unify Picture Mode setting,

Luminance setting, Contrast setting, and Black level setting via the ON-SCREEN-DISPLAY

(OSD) menu.

Refer to the display's documentation for details.

・When an upgrade installation was done while PIP MODE (PbP) has been in ON state, please

execute 7.7.1.1 Re-initialization of Display Configuration (page 105).

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 181 182

Pas de commentaire

NEC GammaCompMD QA Manuel d'utilisateur Page 25