NEC GammaCompMD QA Manuel d'utilisateur télécharger pdf (Page 19)

GammaCompMD QA Client User Manual

 Dialog boxes with only an OK button

Clicking OK closes the dialog box. When displaying a dialog box with display selection

buttons again, the previous selections are cleared. Make the selections again.

 Dialog boxes with OK and Cancel buttons

Clicking OK performs the intended action (enables setting / start calibration / view

report). Clicking Cancel closes dialog box without applying any changes.

 Dialog boxes with OK, Cancel, and Apply buttons

Clicking OK enables settings and closes the dialog box. Clicking Cancel cancels any

change and closes the dialog box. However, the settings that were applied by clicking

the Apply button will not be changed back. Clicking Apply applies settings but does

not close the dialog box.

 Dialog boxes with OK and View buttons

Clicking OK closes the dialog box. Clicking View will cause all changes to be lost in

dialog boxes with checkboxes. Clicking View will show the test pattern.

 Checkboxes

Select All/Deselect All Checkboxes

Checking these will check all available items in dialog box.

Un-checking this will deselect all available items in the dialog box.

NOTE: When the checkbox is in a tab such as in 7.7.1.5 Alert Setup (page 116), it

affects only those checkboxes in the currently selected tab.

 Windows Commands, Menus and Messages

All instructions and menu references related to the Windows operating system are

shown within brackets.

Example: Select the [General] tab on the [Windows Firewall] screen.

2.21. Using PIP Enabled Displays

PIP MODE supported display models are able to display information from more than

one input on one screen at the same time. Please refer to the display’s user manual for

details.

GammaCompMD QA Client can handle configurations where two or more inputs are

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 181 182

Pas de commentaire

NEC GammaCompMD QA Manuel d'utilisateur Page 19