NEC Express5800/R120f-1M Guide de l'utilisateur télécharger pdf (Page 99)

2. Installation and Connection

Chapter 2 Preparations

Installation and Connection

This section describes how to install the server and connect cables.

2.1

Installation

This server must be mounted to a rack which conforms to EIA standards for use.

2.1.1

Installing Rack

Refer to the manual that comes with your rack for how to install the rack, or consult with your sales

representative.

WARNING

Be sure to observe the following precautions to use the server safety. Failure to

observe the precautions may cause death or serious injury. For details,

refer to

Safety Precautions and Regulatory Notices.

• Use only in the specified environment.

• Do not connect the ground wire to a gas pipe.

CAUTION

Be sure to observe the following precautions to use the server safely. Failure to

observe the precautions may cause burns, injury, and property damage.

For

details, refer to Safety Precautions and Regulatory Notices.

• Do not carry or install the server only by a single person.

• Do not install the server so that the load may be concentrated on a specific

point.

• Do not install any components only by a single person.

Confirm that hinge pins of the door are completely secured in place.

• Do not pull out the server from the rack when the rack is unstable.

• Do not leave more than one device being pulled out from the rack.

• Do not provide the wiring for the server to exceed the rating

of the power

supply.

• Do not use the server in the environment where corrosive gas is generated.

Express5800/R120f-1M User’s Guide

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 132 133

Pas de commentaire

NEC Express5800/R120f-1M Guide de l'utilisateur Page 99