NEC Express5800/R120f-1M Guide de l'utilisateur télécharger pdf (Page 112)

1. Turning on the Server

Chapter 3 Setup

4. After a while, the following message is displayed on the screen. (The on-screen message depends on

your environment.)

Press <F2> SETUP, <F3> Internal Flash Memory, <F4> ROM Utility, <F12> Network

By pressing the designated function key following messages, you can call the functions below upon

completion of POST.

<F2> key: Run BIOS Setup Utility (SETUP). For information on the SETUP, see Chapter 2 (1. System

BIOS) in "Maintenance Guide".

<F3> key: Run EXPRESSBUILDER from Internal Flash Memory. For information on

EXPRESSBUILDER, see Chapter 3 (4. EXPRESSBUILDER).

Note

• <F3> key is acceptable only for 5 seconds after the message is displayed.

• If bootable CD/DVD is inserted into optical disk drive, the system starts from

CD/DVD even if <F3> key is pressed.

<F4> key: Run Offline Tools. For information on Offline Tools, see Chapter 1 Maintenance (9. Offline

Tools) in "Maintenance Guide".

<F12> key: Boot from network.

Tips

If One time or Always is specified for Power Management Policy in Server

menu of BIOS SETUP,

a message indicating power consumption is being

measured is displayed instead of the message shown above. Wait for a while until

measurement is complete.

5. When Legacy is specified for Boot Mode, if a controller which has its dedicated BIOS such as a RAID

Controller is installed, a message that prompts you to start the dedicated utility to configure the card is

displayed.

Example: If an optional RAID Controller is installed

Press <Ctrl> <R> to Run MegaRAID Configuration Utility

The utility starts by pressing <Ctrl> + <R> keys.

For details on the utility, refer to the manual supplied with each optional board.

Depending on the configuration, the message "Press Any Key" might appear to prompt a key entry.

This is a behavior of the BIOS of the optional board. Continue to operate after checking the manual

of the optional board.

6. The OS starts when POST is completed.

1.1.2

POST error messages

When POST detects an error, it displays an error message on the screen or beeps for some errors. For

descriptions of error messages, causes, and countermeasures, see Chapter 3 (1. POST Error Message) in

"Maintenance Guide".

Note

Take notes on the indication displayed on display unit

before consulting with your

sales representative. Alarm messages are useful information for maintenance.

Express5800/R120f-1M User’s Guide

112

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 132 133

Commentaires sur ces manuels

Pas de commentaire

NEC Express5800/R120f-1M Guide de l'utilisateur Page 112

Commentaires sur ces manuels

Produits connexes et manuels pour Serveurs NEC Express5800/R120f-1M