NEC Express5800/R120f-1M Guide de l'utilisateur télécharger pdf (Page 113)

2. BIOS Setup Utility (SETUP)

Chapter 3 Setup

BIOS Setup Utility (SETUP)

This section describes how to configure Basic Input Output System (BIOS).

Make sure you have read and understood this section to configure properly.

2.1

Overview

BIOS Setup Utility (SETUP) is a utility to do basic hardware settings. This utility is installed in a flash memory

in the server as standard and can be run without requiring a media for boot.

BIOS settings were configured with optimal settings before the server was shipped to you. Therefore, in most

of cases, you should not need to use the SETUP. Use only when the case applies to any of cases

described in Chapter 3 (2.4 Cases that Require Configuration).

2.2

Starting SETUP Utility

Run POST following Chapter 3 (1.1.1 POST sequence).

After a while, the following message will be displayed on the lower left of the screen. (The on-screen message

depends on your environment.)

Press <F2> SETUP, <F3> Internal Flash Memory, <F4> ROM Utility, <F12> Network

If you press the <F2> key, SETUP starts upon completion of POST, and the Main menu is displayed.

Tips

In Legacy

boot mode, you can also launch SETUP by pressing the <F2> key while

expanding option ROM.

Password

If you have set a password, a message prompt you to enter password will be displayed.

Enter password［］

You can attempt password entry up to 3 times. If you entered an incorrect password 3 times, operation

stops. (You cannot operate further.) Turn off the power.

Saving changes

If you finish configuration, select Save & Exit and then Save Changes and Exit to save changes and exit.

If you wish to exit without saving the changed parameters, select Save & Exit

and then Discard Changes

and Exit.

Tips

• If you wish to restore the setting to default values, select Save & Exit and then Load

Setup Defaults.

• The default value might be different from the factory setting.

• You cannot restore the default value in the following submenus in Advanced menu:

– iSCSI Configuration submenu

– UEFI Driver Configuration submenu

Express5800/R120f-1M User’s Guide

113

1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 132 133

Pas de commentaire

NEC Express5800/R120f-1M Guide de l'utilisateur Page 113