Nec LT 100 Manuel d'utilisateur télécharger pdf (Page 35)

Settings Menu

Enables you to set preferences and other operating options. Use the “Select” button on the projector cabinet or

(▲) (▼) buttons on your remote control to access the submenu you want.

Custom Memory

This enables you to save your current settings for an RGB source in one of five memories, Custom 1-5.

To change the STANDARD settings, proceed as follows:

1. Connect your computer to the MultSync LT100.

2. Select the "STANDARD" in RGB source.

3. Adjust the horizontal/vertical position, Picture, and Fine Picture adjustments.

4. Select the Custom Memory icon.

5. Press the "Adjust" (+) or (–) buttons to choose a memory location, then press "Enter" on the cabinet or the "Left

Click" on your remote control to save the new settings.

If you do not want to change the STANDARD settings, first selct the Custom Memory icon, then do the same as

step 5.

Capture (with the optional viewer board installed only)

When the Capture is selected, press "Enter" on the projector cabinet or Left Click button on the remote control

to display "Execute" and "capture" an image from a source that is currently being displayed.

When capturing is completed, "Completed" is displayed under the Capture icon.

Unless a flash memory card is inserted into the slot of the viewer board, "No Card" is displayed. This means that

the Capture feature is not available. The "Card Error" display means that the free space of the flash memory card

is insufficient for saving images. Make more space available on the card by erasing unwanted images with your

PC. The number of images that can be captured depends on the size of the flash memory card.

OPERATION 68

NOTE: Be sure not to turn off the power or remove the flash memory card unless "Completed" is displayed. Doing so

could cause a loss of the data in the flash memory card or damage to the card itself.

Background

Use this feature to display a black, blue screen or focus pattern when no signal is available. Press the mouse pad (+) or (-) buttons to

choose the back screen you want. Press "Enter" on the cabinet or the "Left Click" on your remote control to save your change.

Projection

This reorients your image based upon projector location. Press the “Adjust” (+) or (–) button until it is correct.

Press “Enter” on the cabinet or the “Left Click” on your remote control to save your change. The options are:

front floor projection, rear ceiling projection, rear floor projection, and front ceiling projection.

Language

Use the “Adjust” (+) or (–) to choose one of six languages for on-screen instructions. Press “Enter” on the cabinet or the

“Left Click” on your remote control to save your change. The options are: English, German, French, Italian, Spanish and

Swedish.

Reset

Changes all adjustments to the factory preset levels for each source individually. To activate, you must hold down the “Adjust”

(+) button on the cabinet or remote control for at least two seconds. The adjustments that will be reset are horizontal and vertical

control, picture and fine picture adjustment (for the current source only), brightness, contrast, color, tint, and sharpness.

When custom setting is selected, reset changes all adjustments to the factory preset levels of the current input signal for

selected custom memory location. This will not return to your previous custom setting and will delete your saved settings

from custom memory.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 51 52

Commentaires sur ces manuels

Pas de commentaire

Nec LT 100 Manuel d'utilisateur Page 35

Commentaires sur ces manuels

Produits connexes et manuels pour Projecteurs Nec LT 100