Nec LT 100 Manuel d'utilisateur télécharger pdf (Page 19)

Using A Tabletop Or Cart

1. Place your projector on a flat level surface at the optimal distance

from the screen or wall so you realize the size image you want.

(Avoid having bright room lighting or sun light directly on the

screen or wall where you'll be projecting the image.)

2. Connect the power cable, remove the lens cap and turn the projector

on. (If no input signal is available, the projector will display a

background image.)

3. Ensure that the projector is square to the screen.

4. Move the projector left or right to center the image horizontally on

the screen. (A)

5. To center the image vertically (B), lift the front edge of the projector

and press the buttons on the front of the projector, just above the

feet, to release the one-touch tilt feet. (There is approximately 5.0˚

of up and down adjustment for the front of the projector.

(A) Top view

(B) Side view

screen

INSTALLATION 36

6. To fine tune the image's position vertically on the screen, rotate each

front foot, and rear feet if necessory.

NOTE: Adjust feet so that lens surface is parallel to the screen.

If you use the projector with the screen tilted, the picture will be

distorted.

7. Adjust the size of the image using the zoom ring lever on the lens.

NOTE: The set up angle of the projector should not exceed 15

degrees, otherwise lamp life could decrease dramatically.

screen

Up Down

Focus ring

Zoom ring lever

Down

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 51 52

Pas de commentaire

Nec LT 100 Manuel d'utilisateur Page 19