Nec LT 100 Manuel d'utilisateur télécharger pdf (Page 26)

Connecting Your DVD Player

You can connect your MultiSync LT100 Projector to a DVD player with the component outputs or Video output. To do so, simply:

1. Turn off the power to your projector and DVD player.

2. If your DVD player has the component video (Y,Cb,Cr) output use the optional 15-pin-to-RCA23 cable to connect your DVD player to the

RGB INPUT connector on the LT100.

For a DVD player without component video (Y,Cb,Cr) outputs, use common RCA cables (not provided) to connect a composite VIDEO

output of the DVD player to the Video Input of the LT100.

3. Turn on the projector and the DVD player.

NOTE: Refer to your DVD player's owner's manual for more information about your DVD player's video output requirements.

Connecting Your Document Camera

You can connect your MultiSync LT100 Projector to a document camera. To do so, simply:

1. Turn off the power to your projector and document camera.

2. Use a standard video cable to connect your document camera to the Video input on your projector.

3. Turn on the projector and the document camera.

NOTE: Refer to your document camera's owner's manual for more information about your camera's video output requirements .

INSTALLATION 50

Connecting Your VCR Or Laser Disc Player

Use common RCA cables (not provided) to connect your VCR or laser disc player to your MultiSync LT100 Projector. To make these connections,

simply:

1. Turn off the power to your projector and VCR or laser disc player.

2. Connect one end of your RCA cable to the video output connector on the back of your VCR, or laser disc player, connect the other end to the

Video input on your projector. Use standard RCA audio patch cords to connect the audio from your VCR, or laser disc player to your projector

(if your VCR, or laser disc player has this capability). Be careful to keep your right and left channel connections correct for stereo sound.

3. Turn on the projector and the VCR, or laser disc player.

NOTE: Refer to your VCR, or laser disc player owner's manual for more information about your equipment's video output requirements.

Connecting An External Monitor

You can connect a separate, external monitor to your projector to simultaneously view on a monitor the image you're projecting. To do so:

1. Turn off the power to your projector and computer, document camera or video source.

2. Use a 15-pin cable to connect your monitor to the RGB OUTPUT connector on your LT100 projector.

3. Turn on the projector and the computer, document camera or video source.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 51 52

Pas de commentaire

Nec LT 100 Manuel d'utilisateur Page 26