Nec LT 100 Manuel d'utilisateur Page 11

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 52
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 10
Top Features
1 Power Button
Use this button to turn the power on and off when Main Power Switch is
on and the projector is on standby.
2 Enter Button
Executes your menu selection.
3 Select (▲▼§ ©) / (+)(–) Buttons
Select: After you press the “Menu” button, use the or button to
select the menu icon of the item you wish to adjust.
(+)(–): Use these buttons while you' re in the Image Adjust mode to
change the level of a selected menu item. These buttons are also
used to set an item in the Power or Settings menus.
4 Menu Button
Displays the on- screen menu.
5 Power Indicator
When the projector is switched On, the green LED blinks for about one
minute, then lights up.
19
INTRODUCTION 20
If the main power is on and you switch it off by pressing POWER
OFF on the remote control or press and hold down the POWER
button on the cabinet for one second, the green LED blinks for
one minute, then lights up and the projector goes on standby.
* The projector will not accept operation instructions for the one
minute during which the LED is blinking during switching on
or off as described above.
6 Status Indicator
When this is lit red continually, it's warning you that the projec-
tion lamp has exceed 1000 hours of service. After this light ap-
pears, it is advisable to replace the projection lamp as soon as
possible.(See page 77.)
When the operating time of the lamp exceeds 1000 hours, the STA-
TUS indicator is lit red continually. In addition the message "LAMP
USAGE XX HOURS" appears continually when the on-screen
menu is not displayed.
If this light blinks red rapidly, it indicates that the lamp house is
not attached properly; if the light blinks slowly it means the pro-
jector's internal temperature is too hot to operate safely. See the
Status Light Messages on page 85 for more details.
(▲▼
§
©
)
MENU
SELECT
-
+
ENTER
STATUS
POWER
ON / OFF
4
3
2
6
5
1
AC IN
MEMU
SELECT
ENTER
STATUS
POWER
ON / OFF
Vue de la page 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 51 52

Commentaires sur ces manuels

Pas de commentaire