Nec MT830TM /1030TM Manuel d'utilisateur télécharger pdf (Page 25)

Connecting Your PC Or Macintosh

Computer

Connecting your PC or Macintosh computer to your MultiSync

MT830 (SVGA) /1030 (XGA) Projector will enable you to project

your computer's screen image for an impressive presentation. All of

these following display standards are supported:

To connect to a PC, Macintosh or computer equipped with an XGA/

SVGA /VGA adapter or compatible graphics adapter, simply:

1. Turn off the power to your projector and computer.

2. If your PC does not support XGA/SVGA/VGA you will need to

install an XGA/SVGA/VGA graphics board. Consult your

computer's owner's manual for your XGA/SVGA/VGA configura-

tion. If you need to install a new board, see the manual that comes

with your new graphics board for installation instructions.

VGA 6402480 for graphics VGA 6402400 for graphics

VGA 6402350 for graphics VGA 7202400 for text

VGA 7202350 for text SuperVGA 8002600

Macintosh at 6402480 Macintosh at 8322624

XGA10242768 Macintosh at 10242768

SXGA128021024 (AccuBlend)

Settings for Monitor Mode

Number of DIP switch

Monitor size

15” multi-scan mode /16”–13”

17” multi-scan mode /19”–13”

19” multi-scan mode /21”–13”

13” fixed mode /6402480

VGA/SVGA mode

16” fixed mode /8322624

19” fixed mode /10242768

S2 S3 S4

NOTE: For settings other than display modes supported by your

Macintosh and MT830/1030, use of the DIP switch may bounce a image

slightly or may display nothing. If this happens, set the DIP switch to the

13” fixed mode and then restart your Macintosh. After that, restore to a

displayable mode and then restart the Macintosh again.

Make sure that the MT830/1030 and your Macintosh are connected with

the pin adapter and the supplied signal cable (mini D-Sub 15-pin connec-

tor) and then restart your Macintosh.

3. Use the signal cable that's supplied to connect your PC or

Macintosh computer to the projector. For a Macintosh, use the

supplied pin adapter to connect to your Mac's video port.

4. Turn on the projector and the computer.

5. If the projector goes blank after a period of inactivity, it may be

caused by a screen saver installed on the computer you've

connected to the projector.

When using a Macintosh with the MT830/1030, set the DIP

switches of the supplied pin adapter according to your resolution.

After setting, restart your Macintosh.

See the following pages for setting of the DIP switches.

•

When using with a Macintosh, XGA/VGA/SVGA is recom-

mended if your Macintosh supports this mode.

• When using with a Macintosh PowerBook, output may not be

set to 10242768 unless “mirroring” is off on your PowerBook.

Refer to owner’s manual supplied with your Macintosh com-

puter for mirroring.

NOTE: A Video Adapter cable manufactured by Apple Computer

is needed for a PowerBook which does not have a mini D-Sub 15-

pin connector.

INSTALLATION

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 52 53

Commentaires sur ces manuels

Pas de commentaire

Nec MT830TM /1030TM Manuel d'utilisateur Page 25

Commentaires sur ces manuels

Produits connexes et manuels pour Projecteurs Nec MT830TM /1030TM