Nec MT830TM /1030TM Manuel d'utilisateur télécharger pdf (Page 13)

INTRODUCTION

5 RGB Input 2 Connector (Mini D-Sub 15 pin)

Connect a Macintosh or compatible computer here using the signal

cable and the monitor adapter that is supplied. Or connect your PC

or other RGB equipment such as IBM or compatible computers.

Use the signal cable that is supplied to connect to a PC.

RGB 2 Audio Input Mini Jack

This is where you connect a second RGB audio output from a

computer or another RGB source.

6 PC Control Port

Use this port to connect your PC to control the MultiSync MT830/

1030 Projector. This enables you to use your PC and serial commu-

nication protocol to control the projector. If you are writing your

own program, command references are on pages 99 to 102.

A cap is put on the port at the factory. Remove the cap when using

the port.

7 Mouse Output Port

Use this port to operate your computer’s mouse functions from the

NEC MultiSync MT830/1030 remote control. When your com-

puter is connected here, the remote sensors on the LCD projector

cabinet will receive your mouse commands.

8 Remote Control Jack

Connect your remote control cable here for wired operation.

9 Built-in Security Slot ( )

This security slot supports the MicroSaver

Security System.

MicroSaver

is a registered trademark of Kensington Microware

Inc. The logo is trademarked and owned by Kensington

Microware Inc.

PC CONTROL MOUSE OUTPUT

REMOTE

CONTROL

INPUT

AUDIORGB INPUT 2

AUDIORGB INPUT 1

AUDIORGB MONITOR OUTPUT

RL/MONO

INPUT AUDIOS–VIDEO

RL/MONO

INPUT AUDIOVIDEO

678

AC IN

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 52 53

Commentaires sur ces manuels

Pas de commentaire

Nec MT830TM /1030TM Manuel d'utilisateur Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Projecteurs Nec MT830TM /1030TM