NEC Express5800/R120d-2M Guide d'installation télécharger pdf (Page 280)

8. Windows OS Parameter File

Express5800/R120d-1M, R120d-2M Installation Guide (Windows)

280

Chapter 1 Installing Windows

Important

• Some data in the hard disk drive might be deleted depending on the system

settings. Pay attention to input parameters.

Backing up user data, as

needed, is recommended.

• Partition size

−

Specify a partition size larger than the minimum required for installing

the operating system. (Refer to Chapter 1 (Before Starting Setup).)

−

The maximum partition size is 2,097,152 MB.

• If you select Create a new partition under Partitioning, the entire contents

of the hard disk drive will be deleted.

• If you select Use the existing partition under Partitioning, data in the boot

partition (if it exists) and system partition is formatted and deleted. Data in

other partitions will be kept.

The figure below shows in which partitions data will be deleted.

Boot partition

Deleted

system partition

Deleted

User data

partition

Retained

•

You cannot reinstall to an existing partition that has been upgraded to a

Dynamic Disk (refer to Chapter 1 (Before Starting Setup)). Do not select

Use the existing partition under Partitioning.

• The following message might be displayed when a created parameter file is

loaded. In this event, installation using an existing partition cannot be

executed. Select Create a new partition under Partitioning for installation. If

there is a data partition, it will be deleted.

1 2 ... 275 276 277 278 279 280 281 282 283 284 285 ... 290 291

Pas de commentaire

NEC Express5800/R120d-2M Guide d'installation Page 280