NEC Express5800/R120d-2M Guide d'installation télécharger pdf (Page 228)

6. Setting Up Windows Server 2003

Express5800/R120d-1M, R120d-2M Installation Guide (Windows)

228

Chapter 1 Installing Windows

21. The following message appears.

If N8103-149/150/151 RAID Controller is connected, press <S> key and go to step 22.

If not, go to step 23.

22. Select the following from the driver list, and then press <Enter> key.

LSI MegaRAID SAS RAID Controller Driver

The screen shown in step 21 appears. Go to step 23.

23. If N8103-107 is connected, press <S> key and go to step 24. If not, go to step 25.

24. Select Adaptec Ultra320 SCSI Cards (Windows 32-bit), and then press <Enter> key.

Note

If the following message appears, press <S> key to proceed.

The screen shown in step 21 appears again. Go to step 25.

25. If N8103-104A is connected, press <S> key and go to step 26.

If not, press <Enter> key and go to step 27.

26. Select LSI Fusion-MPT SAS Driver (Server 2003 32-bit), and then press <Enter> key.

The screen shown in step 21 appears again. Press <Enter> key and go to step 27.

The driver you provided seems to be newer than the Windows

default driver.

Windows already has a driver that you can use for “Adaptec

Ultra 320 SCSI Cards (Windows 32-bit)”

Unless the device manufacturer prefers that you use the

driver on the floppy disk, you should use the driver in

Windows.

1 2 ... 223 224 225 226 227 228 229 230 231 232 233 ... 290 291

Pas de commentaire

NEC Express5800/R120d-2M Guide d'installation Page 228