NEC Express5800/R120f-1M Guide d'installation télécharger pdf (Page 312)

6. Setting Up Windows Server 2008

Express5800/R120f-1M, R120f-2M Installation Guide (Windows)

312

Chapter 1 Installing Windows

6.10

Installation When Multiple Logical Drives Exist

Before starting installation, backup data for future use in case of data loss.

(1) Installation process

− Setup with EXPRESSBUILDER

Important

• Before starting setup, be sure to disconnect hard disk drives from the RAID

Controller that is not used for setup, if the server has two or more RAID

Controllers installed.

• Disconnect an external disk (*) from the server by turning the power of it off

or disconnecting cables. Install those hard disk drives and cables after

setup has completed. Conducting setup with those being connected with

the server may cause existing data to be erased unintentionally.

* Disk array unit (such as iStorage) or hard disk drive in Disk Expansion Unit

Refer to Chapter 1 (6.2 Setup with EXPRESSBUILDER), and proceed with setup.

In this case, EXPRESSBUILDER installs the Windows on the first detected hard disk drive or logical drive.

− Setup with Windows standard installer

1. Refer to Chapter 1 (6.3 Setup with Windows Standard Installer), and start setup.

2. When the following message appears, select the partition to which you want to set up the operating

system.

Select the location to which Windows will be installed

The order and numbers of the disks displayed on the screen might not match the server’s slot of the hard

disk drives. Distinguish between the hard disk drives by viewing the hard disk drive capacity and partition

size displayed on the screen, and then select a drive to install the Windows system.

Selecting an improper drive might cause an unintentional corruption of the existing data. Be careful when

selecting a hard disk drive on which to install the system.

Important

• For details, refer to the following Microsoft website:

http://support.microsoft.com/kb/937251/en-us

•

You cannot edit the drive letters for the system volume or boot volume

after setup is complete. Make sure that the drive letters assigned in this

window are correct, and then proceed with setup.

3. Refer to Chapter 1 (6.3 Setup with Windows Standard Installer), and proceed to setup Windows with

Windows standard installer and the instructions.

Tips

The drive letter might change after installation. If you want to change the drive

letter, use the procedure shown in Changing drive letter assignments below.

1 2 ... 307 308 309 310 311 312 313 314 315 316 317 ... 343 344

Pas de commentaire

NEC Express5800/R120f-1M Guide d'installation Page 312