NEC Express5800/R120f-1M Guide d'installation télécharger pdf (Page 148)

4. Setting Up Windows Server 2012

Express5800/R120f-1M, R120f-2M Installation Guide (Windows)

148

Chapter 1 Installing Windows

4.5

Setting Up Device Drivers

Install and set up device drivers provided for the standard configuration.

For details regarding the installation and setup of a driver for an optional device, refer to the manual supplied

with the optional device.

4.5.1

Installing the LAN drivers

(1) LAN drivers

If EXPRESSBUILDER is used for setup, the LAN driver will automatically be installed.

If the Windows standard installer is used for setup, install Starter Pack to install the LAN driver.

Important

• Teaming of network adapters by using BACS or PROSet is not supported.

• Wake On LAN (WOL) is supported by the standard network adapters only.

However, Wake On LAN in the shutdown state is not supported in the

following case:

Select [Control Panel] - [System and Security] - [Power Options] - [Choose

what the power button does], and if [Turn on fast startup] is selected in

[Shutdown settings] on [System Settings] screen.

When [Turn on fast startup

] is not displayed, fast startup feature is

disabled.

Note

• To change the LAN or BACS driver settings, log on to the system from a local

console using an administrator’s account. Remotely changing the settings by

using the operating system’s remote desktop feature is not supported.

• Be sure to select the Internet Protocol (TCP/IP) check box when specifying an

IP address.

(2) Optional LAN board

This server supports the following optional LAN boards.

Optional LAN boards: N8104-149/150/151/152

The drivers for LAN boards are automatically installed using the OS plug-and-play function.

Note

Using an optional LAN board, perform procedure "4.5.2 Setting up LAN drivers" for each

optional LAN board.

1 2 ... 143 144 145 146 147 148 149 150 151 152 153 ... 343 344

Pas de commentaire

NEC Express5800/R120f-1M Guide d'installation Page 148