Nec GT1150 Manuel d'utilisateur télécharger pdf (Page 79)

E – 71

LAN Mode (Optional)

NOTE: The optional LAN card (GT50LAN) is required for LAN connection.

Start the projector and set the LAN card settings.

Select "Advanced Menu", "Projector Option", then "LAN Mode".

The following menu will be displayed on the screen.

Please ask a network administrator about these settings.

Network Board (Option):

Checking this box will enable the LAN control of the projector from

the network.

Status:

This displays the status of the LAN card that is installed in the pro-

jector.

Connecting .......... Installation of the LAN card is being checked. Once the

LAN card has been detected, the status will change to

"Running".

Running .............. This is the normal condition. (The LAN card has been

detected.)

Connection Error . The installed LAN card cannot be detected. Possibly the

LAN card is not installed, or the LAN/PC CONT switch is

not set correctly.

IP Address:

This sets the IP address of the LAN card

At the same time, this sets the sub net mask of the Local Area

Network being used by this LAN card.

Setting Examples

NOTE: This device makes use of a method that specifies the number of

valid bits in the sub net mask expression.

(1) IP = 10.0.0.1 sub net mask = 255.0.0.0

→ 010.000.000.001/08

(2) IP = 128.1.0.1 sub net mask = 255.255.0.0

→ 128.001.000.001/16

(3) IP = 192.9.200.1 sub net mask = 255.255.255.0

→ 192.009.200.001/24

(4) IP = 210.145.129.145 sub net mask = 255.255.255.240

→ 210.145.129.145/28

Port

This sets the TCP port number when connecting from the control

software. Please be careful not to duplicate another TCP port on the

controller.

Default Gateway

Checking this box will make the set default route valid.

When data is sent from the LAN card, the transfer location will be

searched according to the previously set routing information; how-

ever, when the transfer location has not been found as a result of the

search, the data will be sent to the device that holds the IP address

set here. The IP address that is set here must be one that can be

identified by a search of the routing information.

OK Button

This button sets the LAN card with the setting values that appear on

the screen and closes the screen.

Cancel Button

This button cancels the setting values that appear on the screen

and closes the screen.

Reconnect Button

This button rechecks the LAN card with the setting values that ap-

pear on the screen.

It is used when a "Connection Error" or another fault occurs.

1 2 ... 74 75 76 77 78 79

Commentaires sur ces manuels

Pas de commentaire

Nec GT1150 Manuel d'utilisateur Page 79

Commentaires sur ces manuels

Produits connexes et manuels pour Projecteurs Nec GT1150