NEC Express5800/GT110e-S Guide d'installation télécharger pdf (Page 252)

7. Setup for Solving Problems

Express5800/GT-110e, GT-110e-S, R110e-1E Installation Guide (Windows)

252

Chapter 1 Installing Windows

7.1.3

For Windows Server 2003

Follow the procedure below to specify the memory dump settings.

Tips

Although the procedure below uses Windows Server 2003 as an example,

Windows Server 2003 R2 x64 Edition can be set up using the same procedure.

1. Select Control Panel from the Start menu, and then click System.

The System Properties dialog box appears.

2. Click the Advanced tab.

3. Click [Settings] under Startup and Recovery.

4. Specify the folder to store the debug information in the Dump file: text box.

Example: To store the debug information in D drive under the file name MEMORY.DMP:

D:\MEMORY.DMP

Note the following when specifying a dump file.

For Windows Server 2003 R2 x64 Edition

• For the Write debugging information drop-down list, we recommend specifying Complete

memory dump. If the mounted memory size is greater than 2 GB, however, Complete memory

dump cannot be specified because it is not displayed on the drop-down list. In this case,

specify Kernel memory dump instead.

• Specify a drive that has a free space of at least "the memory capacity mounted on the server +

1 MB".

• If you attempt to add memory that will cause the mounted memory size to exceed 2 GB,

specify Kernel memory dump from the Write debugging information drop-down list before

adding the memory. The size of the debug information (memory dump) to be collected

changes if memory is added. Make sure that the free space of the drive to store the debug

information (memory dump) is sufficient.

For Windows Server 2003

• For the Write debugging information drop-down list, we recommend specifying Complete

memory dump. If the mounted memory size is greater than 2 GB, however, Complete

memory dump cannot be specified because it is not displayed on the drop-down list. In this

case, specify Kernel memory dump instead.

• Specify a drive that has a free space of at least "the memory capacity mounted on the

server + 12 MB" (or 2048 MB + 12 MB if the memory size exceeds 2 GB).

• If you attempt to add memory that will cause the mounted memory size to exceed 2 GB,

specify Kernel memory dump from the Write debugging information drop-down list before

adding the memory. The size of the debug information (memory dump) to be collected

changes if memory is added. Make sure that the free space of the drive to store the debug

information (memory dump) is sufficient.

5. Click [Settings] under Performance.

The Performance Options dialog box appears.

6. Click the Advanced tab on the Performance Options dialog box.

7. Click [Change] under Virtual memory.

1 2 ... 247 248 249 250 251 252 253 254 255 256 257 ... 274 275

Commentaires sur ces manuels

Pas de commentaire

NEC Express5800/GT110e-S Guide d'installation Page 252

Commentaires sur ces manuels

Produits connexes et manuels pour Logiciel NEC Express5800/GT110e-S