NEC Express5800/HX6100 Guide de l'utilisateur télécharger pdf (Page 152)

6-8

Problem Solving

Monitoring POST while it is running

Each time you turn on the system, the power-on self-

test (POST) runs automatically and checks the system

board, CPU, memory, keyboard, and most installed

peripheral devices.

During the memory test, POST displays the amount of

memory that it is able to access and test. Depending on

the amount of memory, it may take several minutes to

complete the memory test. When the memory test

completes, the following is displayed:

Press <F2> to enter SETUP

Press <F2> if you want to run BIOS Setup. When the

utility appears, follow the instructions on your monitor

to configure BIOS. See Chapter 4, Configuring Your

System. If you do not press <F2>, the above message

remains for a few seconds and the boot process

continues.

When this message appears:

Press <Ctrl><A> for SCSISelect™ Utility!

Press <Ctrl+A> if you want to configure SCSI devices in

your system. When the utility appears, follow the

instructions on your monitor to configure the SCSI host

adapter settings and run the SCSI disk utilities. See

Chapter 4, Configuring Your System. If you choose not

to run the SCSISelect Utility, the boot process

continues.

If POST finds an error, it displays an error message.

This information is useful to your service

representative. Refer to the Error Message section in

this chapter for an explanation of each error code.

The BIOS indicates errors by writing an error code to

the PS/2-standard logging area in the Extended BIOS

Data Area, and by displaying a message on the screen,

which is sometimes preceded by the POST Error Code.

The error code will also be logged to the Event Logging

area.

1 2 ... 147 148 149 150 151 152 153 154 155 156 157 ... 191 192

Pas de commentaire

NEC Express5800/HX6100 Guide de l'utilisateur Page 152