4-33
Configuring Your System
2. Power off the system and turn the power back on.
3. When the system beeps and the diskette drive LED
is lit, the system is copying the recovery code into
the FLASH. As soon as the system emits a long beep,
the recovery is complete.
4. Power off the system.
5. Remove the Multi-Language BIOS FLASH diskette 2
of 2 from floppy disk drive A. Proceed to the
previous procedure to change the BIOS Setup
language.
Resetting the CMOS NVRAM
To reset the CMOS NVRAM:
1. Power off the system and remove the panels as
described in chapter 5 of this guide.
2. Move the CMOS Clear switch 13A SW1 to OFF (see
Figure 4-3).
3. Turn the system on and wait for the POST to
complete. This will automatically reprogram the
CMOS NVRAM to the default settings.
4. Power off the system.
5. Move the CMOS Clear switch back to ON.
6. Replace the panels and power on the system.
7. Run the Setup Utility to configure your system.
Commentaires sur ces manuels