NEC Express5800/HX6100 Guide de l'utilisateur télécharger pdf (Page 126)

5-36

Upgrades and Options

Installing a 5 1/4-Inch Device or 3 1/2-Inch Diskette Drive

Caution: CD-ROM devices contain a laser system and

are classified as CLASS 1 LASER PRODUCTS. In case

of any trouble with a CD-ROM, please contact your

nearest service representative. To prevent direct

exposure to the laser beam, do not try to open the

enclosure.

Use of controls or adjustments or performance of

procedures other than those recommended by the

manufacturer may result in hazardous radiation

exposure

Note: If you are replacing a diskette drive in Bay E or

installing a diskette drive in bay F, use the internal

diskette drive cables provided with the system. If you

are installing a SCSI device in bays A, B, or C, you

must use the internal SCSI cables. Contact your sales

representative or dealer for a list of approved optional

peripheral devices.

1. Power off the system. Remove the left front door and

the top cover as described earlier in this chapter.

2. Each empty media or diskette drive bay has a blank

panel tray. From the bay where you want to install a

drive, remove the two screws securing the blank

panel tray to the chassis (Figure 5-18).

Note: When installing a full height 5 1/4-inch

device, remove two blank panels.

3. Grasp the blank panel tray and slide it out of the

bay.

4. Remove the two screws securing each side rail to the

blank panel tray (Figure 5-19).

5. Save the blank panel tray and screws to reuse if you

remove a drive from a bay later and do not reinstall

one.

1 2 ... 121 122 123 124 125 126 127 128 129 130 131 ... 191 192

Pas de commentaire

NEC Express5800/HX6100 Guide de l'utilisateur Page 126