NEC Express5800/320La Guide de l'utilisateur Page 131

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 206
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 130
CRU Replacement and Server Upgrades 4-45
Replacing the Device Module
Your system contains two standard PC AT compatible peripheral devices that
are housed in the device module. The standard peripheral devices are as follows:
!
Super floppy disk drive
!
24X CD-ROM drive (supports 650 MB CD media).
The device module is a single CRU and is not hot-pluggable.
You must open the front door of the tower cabinet or the front cover of the rack-
mount system to turn the server power off before removing or installing the
device module.
!
CAUTION
CD-ROM devices contain a laser system and are classified
as CLASS 1 LASER PRODUCTS. In case of any trouble
with a CD-ROM, please contact your nearest service
representative. To prevent direct exposure to the laser
beam, do not try to open the enclosure.
Use of controls or adjustments or performance of
procedures other than those recommended by the
manufacturer may result in hazardous radiation exposure.
To replace the device module perform the following procedures (see Figure
4-56).
1. Observe the safety and ESD precautions listed at the beginning of this
chapter.
2. Unlock and open the front door on the tower cabinet or front covers on the
rack-mount system. See Opening and Closing the Front Door of the Tower
Cabinet earlier in this chapter or Removing and Installing the Front Covers
of the Rack-Mount System earlier in this chapter.
3. Power off the system. Ensure the power cords are unplugged from the AC
wall outlet.
4. Remove the two screws securing the device module to the front panel of the
cabinet.
5. While holding the upper and lower tabs protruding from the device module
carefully pull it out of the cabinet.
Vue de la page 130
1 2 ... 126 127 128 129 130 131 132 133 134 135 136 ... 205 206

Commentaires sur ces manuels

Pas de commentaire