NEC Express5800/320La Guide de configuration télécharger pdf (Page 39)

ESMPRO Agent for Linux 3-7

Base Settings

The Agent can respond to an event using any of the three methods selected in

the Base Setting menu, but only if the method is enabled and configured. The

report contents include a detailed message, support method, and the alert type.

Manager - Select this setting to use SNMP as the reporting method to send

alerts to the Manager. For this method to work you must specify the manager

console’s IP address as an SNMP trap destination.

Manager (TCP_IP In-Band) – Select this setting to use TCP/IP to send an

alert to a manager within the local-area network (LAN environment).

Manager (TCP_IP Out-of-Band) – Select this setting to use TCP/IP to send an

alert to a manager outside of the local-area network using remote access service

over a dial-up network (WAN environment).

Shutdown Delay- Enter a time period for the shutdown delay.

When the managed server receives a command to shut down, it will first display

a pop-up message to alert you of the impending shut down. You can cancel the

shutdown from the pop-up message. If you don't respond to the pop-up message,

the managed server shuts down. The time delay you specify here on the

Shutdown Delay Setting dialog box is the amount of time the pop-up message

appears on the screen of the managed server before it shuts down.

Note: To enable remote shutdown, enable “Shutdown

Delay” in the “Base Setting” window of the “Alert Manager

Report Setting Utility (./ESMamsadm).” Refer to the “Report

Setting” section found earlier in this chapter. Also, enable

“Remote Shutdown” in the “General Properties” screen of

the ESMPRO Agent Configuration Utility (./ESMagntconf).”

See “Monitoring Function – General Properties” found later

in this chapter.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 101 102

Pas de commentaire

NEC Express5800/320La Guide de configuration Page 39