NEC Express5800/320La Guide de configuration télécharger pdf (Page 31)

Configuring Linux 2-23

Perform the following steps to reinstall Linux:

1. Insert the install disk into the floppy disk drive, and insert backup CD-

ROM1 into the CD-ROM drive immediately after turning on the power.

Installation starts. A message is displayed after a short time.

2. Remove backup CD-ROM1 and insert backup CD-ROM2 according to the

message.

3. Press Enter.

The message "Congratulation! Install Complete" is displayed at completion

of the installation.

4. Press Enter.

Backup CD-ROM2 is ejected and rebooting starts. Remove the install disk

and backup CD-ROM2.

After rebooting, the root password changes to the factory-set one at purchase

of the server. For the factory-set password, see the attached paper

"Administrator (root) password" provided with the server. After logging in

the system with root, change to an arbitrary password to provide security.

IMPORTANT: After the system restarts, two disks enter the “RESYNCING”

state in order to complete the building of the RAID. While the disks are in this

state, do not remove them, turn off the power, or restart the system. Wait until

RESYNCING" or "RECOVERY" has completed. (You can confirm the current

RAID status by executing ftdiskadm.) If you should accidentally reboot your

system during the "RESYNCING" or "RECOVERY" state, the data on your

disks has not been corrupted. After reboot, the "RESYNCING" of your disks

restarts from the beginning. Your server is not in a fault tolerant state until

"RESYNCING" has completed.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 101 102

Pas de commentaire

NEC Express5800/320La Guide de configuration Page 31