Nec GT2150 Manuel d'utilisateur télécharger pdf (Page 36)

E – 26

Using OUTPUT Connectors

You can connect a separate, external monitor to your GT2150 projec-

tor to simultaneously view on a monitor the RGB analog, or compo-

nent image you're projecting. To do so:

1. Turn off the power to your projector, monitor and computer.

2. Use a 15-pin cable to connect your monitor to the ANALOG OUT-

PUT (Mini D-Sub 15 pin) connector on your projector.

3. Turn on the projector, monitor and the computer.

NOTE: The ANALOG OUTPUT connector outputs RGB signal during standby.

When the projector goes into standby, the image on an external monitor disap-

pears for a moment.

The DVI DIGITAL OUTPUT connector outputs all input signals.

The DVI DIGITAL OUTPUT connector is designed for Link mode only.

Do not connect the other equipment than another projector to this con-

nector.

L/MONO

RGB 2

RGB 1

VIDEO 1

VIDEO 2

VIDEO AUDIO OUT

R/Cr G/Y B/Cb

VH/HV

L/MONO R

L/MONO R L/MONO R

L/MONO R

OUTPUT

ANALOG

DVI DIGITAL

L/MONO

RGB 2

RGB 1

VIDEO 1

VIDEO 2

VIDEO AUDIO OUT

R/Cr G/Y B/Cb

VH/HV

L/MONO R

L/MONO R L/MONO R

L/MONO R

OUTPUT

ANALOG

DVI DIGITAL

To DVI digital

Connecting a PC with DVI output

The DVI (digital) input accepts up to the SXGA@60Hz signal.

SXGA signals with 110 MHz or over of pixel clock cannot be supported.

NOTE: The Auto Adjust feature does not work for DVI digital signal. When DVI

signal is selected and the image position is not corrected, adjust the horizontal

and vertical position using the Position/Clock screen. See page E-43 for more

details.

DVI cable (not supplied)

DVI DIGITAL Input

Slave projector

Master projector

Supplied ferrite clamp core

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 73 74

Commentaires sur ces manuels

Pas de commentaire

Nec GT2150 Manuel d'utilisateur Page 36

Commentaires sur ces manuels

Produits connexes et manuels pour Projecteurs Nec GT2150