NEC NP-UM330X Manuel d'utilisateur télécharger pdf (Page 130)

120

7. Maintenance

 Replacing the Lamp and the Filters

Whenthelampreachestheendofitslife,theLAMPindicatorinthecabinetwillblinkredandthemessage“THE

LAMPHASREACHEDTHEENDOFITSUSABLELIFE.PLEASEREPLACETHELAMPANDFILTER.”willappear

(*).Eventhoughthelampmaystillbeworking,replacethelamptomaintaintheoptimalprojectorperformance.After

replacingthelamp,besuretoclearthelamphourmeter.(→page102)

CAUTION

• DONOTTOUCHTHELAMPimmediatelyafterithasbeenused.Itwillbeextremelyhot.Turntheprojectoroff

andthendisconnectthepowercord.Allowatleastonehourforthelamptocoolbeforehandling.

• Usethespeciedlampforsafetyandperformance.

 Toorderthereplacementlamp,specifyyourlamptype.

 Replacementlamp:

 NP17LP-UM:UM330X/UM330W

 NP16LP-UM:UM280X/UM280W

 Thereplacementlampcomeswithlters.Whiletheltersattachedtotheprojectoratthetimeofpurchaseare

madeofdarkspongematerial,theltersincludedwiththeoptionallamparemadeofnon-wovenwhitematerial.

Thereisnodifferenceinperformancebetweenthesetwotypes.

• DONOTREMOVEANYSCREWSexceptonelampcoverscrewandtwolamphousingscrews.Youcouldreceive

anelectricshock.

• Donotbreaktheglassonthelamphousing.

 Keepngerprintsofftheglasssurfaceonthelamphousing.Leavingngerprintsontheglasssurfacemightcause

anunwantedshadowandpoorpicturequality.

• Theprojectorwillturnoffandgointostandbymodewhenyoucontinuetousetheprojectorforanother100hours

afterthelamphasreachedtheendofitslife.Ifthishappens,besuretoreplacethelamp.Ifyoucontinuetouse

thelampafterthelampreachestheendofitslife,thelampbulbmayshatter,andpiecesofglassmaybescattered

inthelampcase.Donottouchthemasthepiecesofglassmaycauseinjury.Ifthishappens,contactyourNEC

dealerforlampreplacement.

*NOTE:Thismessagewillbedisplayedunderthefollowingconditions:

• foroneminuteaftertheprojectorhasbeenpoweredon

• whenthe (POWER)buttonontheprojectorcabinetorthePOWEROFFbuttonontheremotecontrolispressed

Toturnoffthemessage,pressanybuttonontheprojectorcabinetortheremotecontrol.

Optionallampandtoolsneededforreplacement:

• Phillipsscrewdriver(plus-head)

• Replacementlamp

Flow of Replacing the Lamp and the Filters

Step 1. Replace the lamp

Step 2. Replacethelters(→ page 123)

Step 3. Clearthelampusagehoursandthelterusagehours(→ page 102)

1 2 ... 125 126 127 128 129 130 131 132 133 134 135 ... 148 149

Pas de commentaire

NEC NP-UM330X Manuel d'utilisateur Page 130