NEC Express5800/R110f-1E Guide d'installation télécharger pdf (Page 12)

Installation

Express Report Service must be installed after the installation of NEC ESMPRO Agent or NEC ESMPRO

ServerAgentService (Service Mode).

Tips

If NEC ESMPRO ServerAgentService (Non-Service Mode) cannot install Express

Report Service. Install NEC ESMPRO ServerAgentService (Service Mode).

Start installation after the system starts completely.

If installation is conducted right after the system startup, it may fail. Wait for a while and retry if the error

message appears.

Important

If [Exit] is clicked during installation, the following message appears. Click [OK] and

wait until that the configuration set up in the installation is deactivated.

1. Sign-in (Log on) to the system with the built-in administrator, which has

administrative privileges.

2. Insert EXPRESSBUILDER into Optical disk drive.

EXPRESSBUILDER Autorun Menu is automatically displayed by Autorun function.

Tips

● If Autorun Menu does not launch, double-click ¥autorun¥dispatcher_x64.exe

from EXPRESSBUILDER.( 32bit : dispatcher.exe)

● On ServerCore environment, following the instructions in the

"EXPRESSBUILDER Command Line Interface User's Guide", start the setup

program. Name that support will be less.

"/modules/ESMPRO_AMEXP"

After you start the setup program, follow the instructions in step 5 or later.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 94 95

Pas de commentaire

NEC Express5800/R110f-1E Guide d'installation Page 12