NEC Express5800/320Lb Linux Guide de l'utilisateur télécharger pdf (Page 52)

4-8 Linux Setup

(2) Make sure that the two BMC Status LEDs of the PCI modules (for Group1/for Group2) are

turned off.

IMPORTANT: While the BMC Status LED is red and blinking, do not

perform (3) and on. Otherwise the BMC firmware may become damaged.

(3) Remove the power cord of the AC inlet A (for Group2).

(4) Check that the POWER switch of the PCI module for Group1 is turned on.

(5) Connect the power cord of the AC inlet A (for Group2).

(6) Make sure that two BMC Status LED for PCI modules (for Group 1/for Group 2) are

turned off.

IMPORTANT: If the BMC Status LED is red and blinking, do not start

installing Linux for NEC Express5800/ft series. Otherwise the setup may not be

done properly.

Preparation is now completed. Start the installation of Linux for NEC Express5800/ft series.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 81 82

Pas de commentaire

NEC Express5800/320Lb Linux Guide de l'utilisateur Page 52