NEC SigmaBlade AD106a Guide de l'utilisateur télécharger pdf (Page 153)

Upgrading Your Storage and I/O Blade 9-7

Notes

Note the followings in the installation or removal of the mezzanine card.

 Be careful not to make your hands touch the terminals of the mezzanine card slot directly.

Otherwise, the oil and/or dirt on the hands may adhere to the terminals to result in contact

failure.

 For the option ROMs on the unbooted mezzanine card, set "Disabled" with the BIOS

SETUP utility.

Installation

Install a mezzanine card in mezzanine card slot in the following procedure.

IMPORTANT: There are two types of mezzanine card for blade, Type

I and Type II.

The Type I mezzanine card can be installed in either of connectors Type

I and Type II.

The Type II mezzanine card can be installed in Type II connector only.

To install the Type I mezzanine card, start installation from the bottom

slot (for Type I).

NOTE: Before installing mezzanine card, make sure that the shape of

mezzanine card slot matches with that of connector of the option card.

1. After the shutdown processing for the CPU blade in the slot adjacent to the Storage and

I/O Blade to be removed, turn off the power of the CPU blade. The Storage and I/O Blade

is powered off automatically.

2. Pull out the Storage and I/O Blade from the Blade Enclosure.

3. Place the Storage and I/O Blade on anti-static sheet with little dust.

4. If N8403-032 joint bracket for AD106a is mounted, remove a single screw, then remove

the joint bracket from the chassis.

1 2 ... 148 149 150 151 152 153 154 155 156 157 158 ... 161 162

Pas de commentaire

NEC SigmaBlade AD106a Guide de l'utilisateur Page 153