Nec NP-P350X Manuel d'utilisateur télécharger pdf (Page 115)

5. Using On-Screen Menu

Using Test Pattern [TEST PATTERN]

Displaysthetestpatterntocheckforimagedistortionatthetimeoftheprojectorsetup.PresstheENTERbuttonto

displaythetestpattern;presstheEXITbuttontoclosethetestpatternandreturntothemenu.Menuoperationand

keystonecorrectionarenotpossiblewhenthetestpatternisdisplayed.

[NETWORKING SETTINGS]

See“APPLICATIONMENU”onpage107.

[OPTIONS(1)]

Setting Auto Adjust [AUTO ADJUST]

ThisfeaturesetstheAutoAdjustmodesothatthecomputersignalcanbeautomaticallyormanuallyadjustedfor

noiseandstability.Youcanautomaticallymakeadjustmentintwoways:[NORMAL]and[FINE].

OFF �� The computer signal will not be automatically adjusted� You can manually optimize the computer signal�

NORMAL �� Default setting� The computer signal will be automatically adjusted� Normally select this option�

FINE �� Select this option if ﬁne adjustment is needed� It takes more time to switch to the source than when [NOR-

MAL]is selected�

Selecting Fan Mode [FAN MODE]

Thisoptionallowsyoutoselectthreemodesforfanspeed:Automode,Highspeedmode,andHighAltitudemode.

AUTO �� The built-in fans automatically run at a variable speed according to the internal temperature�

HIGH �� The built-in fans run at high speed�

HIGH ALTITUDE �� The built-in fans run at a high speed� Select this option when using the projector at altitudes approximately

5500 feet/1600 meters or higher�

Whenyouwishtocooldownthetemperatureinsidetheprojectorquickly,select[HIGH].

NOTE:

• When[HIGHALTITUDE]isselectedfor[FANMODE],asymbolicon willbedisplayedatthebottomofthemenu.

• ItisrecommendedthatyouselectHighspeedmodeifyouusetheprojectornon-stopforconsecutivedays.

•Set[FANMODE]to[HIGHALTITUDE]whenusingtheprojectorataltitudesapproximately5500feet/1600metersorhigher.

• Usingtheprojectorataltitudesapproximately5500feet/1600metersorhigherwithoutsettingto[HIGHALTITUDE]cancause

theprojectortooverheatandtheprotectorcouldshutdown.Ifthishappens,waitacoupleminutesandturnontheprojector.

•Usingtheprojectorataltitudeslessthanapproximately5500feet/1600metersandsettingto[HIGHALTITUDE]cancausethe

lamptoovercool,causingtheimagetoicker.Switch[FANMODE]to[AUTO].

•Usingtheprojectorataltitudesapproximately5500feet/1600metersorhighercanshortenthelifeofopticalcomponentssuch

asthelamp.

• Yoursettingwillnotbeaffectedevenwhen[RESET]isdonefromthemenu.

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 221 222

Pas de commentaire

Nec NP-P350X Manuel d'utilisateur Page 115