Nec LT265 Manuel d'utilisateur télécharger pdf (Page 105)

Installation

Selecting Projector Orientation [Orientation]

This reorients your image for your type of projection. The options are: desktop front projection, ceiling rear projection,

desktop rear projection, and ceiling front projection.

NOTE: Selecting one of the other options than “Desktop Front” will force the “Keystone” mode to be “Manual".

Selecting Aspect Ratio and Position for Screen [Screen]

Screen Type........... Select one of three options: 4:3 Screen or 16:9 Screen for the screen to be used. See also "Aspect Ratio" on

page 81.

Position ................. This feature allows you to adjust the vertical position of the image when 16:9 has been selected for the

screen type.

When 16:9 has been selected there is black area above and below the image. You can adjust the vertical

position of the image in these areas.

You can adjust the vertical position between top and bottom.

NOTE: This option is available only when "16:9" is selected in Screen Type.

NOTE: During 3D Reform adjustment, "Screen Type" and "Screen Position" may not be available. To make available, first reset the

3D Reform data and then do settings again. Secondly repeat the 3D Reform adjustment. Changing "Screen Type" and "Screen

Position" can limit 3D Reform in its adjustable range.

6. Using On-Screen Menu

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 144 145

Pas de commentaire

Nec LT265 Manuel d'utilisateur Page 105