Nec XP29 Plus Manuel d'utilisateur télécharger pdf (Page 10)

Terminal Board

DIP SW REMOTE

EXT SPEAKERS

SPEAKERS MUST HAVE

MORE THAN 5WATT RATING

IMPEDANCE 8 OHM

AC IN

SPEAKER SELECT

RIGHT LEFT

HIGH

INT EXT

BNC

OUT

R L(MONO)

AUDIO

THROUGHPUT

VIDEO 1

OUT

1 2 3 4 5 6 7 8

HIGH

RGB1

PC / EXT CTL

HIGH

BNC

OUT

R L(MONO)

AUDIO

VIDEO 2

OUT

RGB

OUT

L(MONO)

OUT

HIGH

RGB AUDIO RGB 2

H RGB 2

R, G, B, H and V IN (BNC) ....... These are analog RGB input terminals.

Connect external components with R, G, B, H, and V output terminals to

these analog RGB input terminals. Be sure that the RGB connection cable

is correctly attached to the corresponding terminals.

R, G, B, H and V THROUGH OUT (BNC) ..... Connect to a second monitor’s

RGB inputs to relay the RGB signal inputs at R, G, B, H, and V IN.

75 Ω/HIGH Impedance Select Switches for RGB and HV .... Set to “75 Ω”

during normal operation. In multiple connections using R, G, B, H and V IN

and OUT terminals, set to “HIGH” on all but the last monitor. Set to “75 Ω”

on the last monitor only.

I DIP Switch

DIP SW ..... This DIP switch sets Sync. Control, the Intelligent Power

Manager, external control on/off, remote control on/off, and OSM system

control on/off. See pages 17 and 18 for more details.

J REMOTE IN/OUT

Connect the optional remote cable to the REMOTE IN terminal. The

REMOTE OUT terminal is used to connect several monitors together and

allows all of the monitors to be controlled by one remote control.

NOTE: Up to 50 monitors can be connected in the serial connection.

K PC/EXT CTL IN(D-Sub 15-pin)

This terminal is used when power ON/OFF, input selection, AUDIO MUTE,

PICTURE MUTE, and DEGAUSS are operated externally (by external

control). See also page 43 for external control port pin assignments. You

can also use this connector to connect your PC to control the MultiSync

XP29 Plus/XM29 Plus monitor. This allows you to utilize your PC and serial

communication protocol to control the monitor.

NOTE: Select EXT. CONTROL ON by setting pin No. 6 of DIP SW to

the ON position when operating the monitor by external control.

NOTE: When in the EXT. CONTROL mode, the following operations of

the supplied wireless remote control are not possible: Power control

ON/ OFF, Input selection, Audio mute ON/OFF, and Degauss switch

ON/OFF.

PC/EXT CTL OUT (D-Sub 15-pin) .....Connect to a second monitor’ s PC/EXT

CTL input to relay the signal input at the PC/EXT CTL IN. The PC/EXT CTL

OUT terminal is used to connect several monitors together and allows all of

the monitors to be controlled by one external control. No. 6 pin (EXT.

CONTROL) of DIP SW must be set to the ON position on all of the

monitors.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 39 40

Commentaires sur ces manuels

Pas de commentaire

Nec XP29 Plus Manuel d'utilisateur Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Moniteurs Nec XP29 Plus