NEC 500 Manuel d'utilisateur télécharger pdf (Page 6)

Quick Start –continued

To attach the AccuSync

™

monitor to your system, follow these

instructions:

1. Turn off the power to your computer.

2. If necessary, install the display card into your system. For more information,

refer to the display card manual.

3. For the PC: Plug the end of the video signal cable of the monitor in the video

signal connector of the computer. (Figure A.1). Tighten all screws.

For the Mac: Connect the Macintosh cable adapter (not included) to the

monitor connector on the Macintosh (Figure B.1). Attach the 15-pin mini

D-SUB end of the video signal cable to the Macintosh cable adapter on

the computer (Figure B.1). Tighten all screws.

NOTE: To obtain the AccuSync Macintosh cable adapter, call NEC-Mitsubishi

Electronics Display of America, Inc. at (800) 632-4662.

4. Connect one end of the power cord to the AccuSync monitor and the other

end to the power outlet (Figure C.1).

NOTE: If you use this monitor at AC125-240V, please refer to Recommended Use

section of this manual for proper selection of power cord.

5. Turn on the monitor and the computer.

NOTE: If you have any problems, please refer to the Troubleshooting section of

this User’s Manual.

Figure A.1

15-pin mini D-SUB

Captive Signal Cable

AS500700700M900FINAL2.p65 11/11/03, 1:45 PM4

1 2 3 4 5 6 7 8 9 10 11 ... 55 56

Pas de commentaire

NEC 500 Manuel d'utilisateur Page 6